Sprinter 2500 V6-3.0L DSL Turbo (2008)
If a CM2100 PCM was replaced, perform the following additional steps and/or routines:
1. PCM Replaced - if WCM equipped
2. Check PCM VIN - if NOT WCM equipped
3. Enable / Disable Vehicle Features - need to enable features
4. Injector Quantity Adjustment
5. Reset Regenerative Filter Timers
6. Mobile DeSoot - NO Minimum Required Soot Load
If an Aisin TCM was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
If an NGC4 TCM ONLY was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an NGC3 TCM ONLY was replaced, perform the following additional steps and/or routines:
1. Quicklearn
If an EATX TCM was replaced, perform the following additional steps and/or routines:
1. Quicklearn
STEP-BY-STEP INSTRUCTIONS
Check PCM VIN
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Check PCM VIN" and follow the on screen instructions.
-
When complete, select "Finish"
Diesel Particulate Filter (Used) Learning
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Diesel Particulate Filter (Used) Learning" and follow the on screen instructions.
-
When complete, select "Finish"
ECU Replacement with Value Transfer
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "ECU Replacement with Value Transfer" and follow the on screen instructions.
-
When complete, select "Finish"
ECU Replacement without Value Transfer
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "ECU Replacement without Value Transfer" and follow the on screen instructions.