Sprinter 2500 V6-3.0L DSL Turbo (2008)
Injector Quantity Adjustment procedure.
NOTE: Before performing this procedure, if the ECU has been replaced, or if any injector has been installed anywhere but its original location,
make a note of the seven digit alphanumeric codes and the physical location of each injector. You will need to enter them into the scan tool
during the Injector Quantity Adjustment procedure.
1. Turn ignition switch "ON".
2. Using a scantool, select ECU View, then MISCELLANEOUS FUNCTIONS.
3. Select Injector Quantity Adjustment, then NEXT.
4. If the ECU was replaced, the Injector EEPROM Location procedure must be performed. Select YES, then NEXT, and follow the directions on the
scan tool. Otherwise, go to step 5.
5. Select the injector(s) that has been replaced, access the keyboard function, and type the seven digit alphanumeric code next to the cylinder number
that corresponds to the physical location where the injector has been installed.
6. Click NEXT. The scan tool will prompt to turn the ignition switch off for 12 seconds.
7. Repeat step 5 and 6 for any other injectors that are new, or have been moved from their original location. Once injectors are classified, cycle
ignition to complete.
8. Once the seven digit alphanumeric codes for all injectors have been entered into the ECU, cycle ignition to complete the procedure.
