Sprinter 2500 V6-3.0L DSL Turbo (2008)
Vacuum Pump: Service and Repair
Installation
INSTALLATION
1. Clean all sealing surfaces.
2. Position driver on rear of pump and install vacuum pump with new seals. Tighten bolts to 14 Nm (124 in. lbs.).
3. Install vacuum line to vacuum pump.
4. Connect negative battery cable.
WARNING: Use extreme caution when the engine is operating. Do not stand in a direct line with the fan. Do not put your hands near the
pulleys, belts or fan. Do not wear loose clothes.
5. Start the engine and inspect for leaks.
