Sprinter 2500 V6-3.0L DSL Turbo (2008)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
Removal
REMOVAL
1. Disconnect the negative battery cable.
2. Remove engine cover.
3. Disconnect camshaft position sensor harness connector (1).
4. Remove the camshaft position sensor retaining bolt (2) and remove camshaft position sensor (3).
Installation
INSTALLATION
1. Install camshaft position sensor (3) and tighten camshaft position sensor bolt (2) to 8 Nm (71 in.lbs.).
2. Reconnect the camshaft position sensor harness connector (1).
3. Install engine cover.
4. Reconnect negative battery cable.
