C 3500 Truck 2WD V8-8.1L VIN G (2001)
Installation Procedure
Important: The seal installer will set the rear oil seal to the proper depth. Failure to use the seal installer will cause improper installation of the oil
seal.
1. Using the J 44732 install the rear oil seal. The seal installer will set the seal at the proper depth.
2. Install the propeller shaft yoke.
3. Use the J 8614-01 in order to hold the transmission from rotating.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the new propeller shaft yoke nut.
^
Tighten flange nut to 330 Nm (244 ft. lbs.).
5. Install the rear propeller shaft.
6. Inspect for the correct transmission oil level.
7. Lower the vehicle.