Canyon 2WD L4-2.9L (2008)
3. Connect the VCIM electrical connectors as necessary.
4. Install the service panel.
Important: After replacing the VCIM, you must reconfigure the OnStar(R) system. Failure to reconfigure the system will result in an
additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of
the OnStar(R) system. This action will cause a DTC to set.
5. Reconfigure the OnStar(R) system. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .
