K 1500 Truck 4WD V8-4.8L VIN V (1999)
INSTALLATION PROCEDURE
1. Clean the debris and the dust from the park brake components using a clean towel.
2. Align the slots in both the adjusting screw and tappet to be parallel with the backing plate face.
3. Position the park brake shoe on the inboard side of the actuation.
4. Slide the parking brake shoe into position and seat into the retaining spring.
5. Inspect the shoe assembly position. The shoe must be central on the backing plate with both tips located in the slots.
6. Adjust the park brake shoe.
7. Install the axle shaft.
8. Install the rotor.
9. Install the park brake cable to the park brake lever.
NOTICE: Refer to Fastener Notice in Service Precautions.
10. Tighten the nut to the intermediate cable at the equalizer.
-
Tighten the nut to 3.5 Nm (31 inch lbs.).
11. Install the caliper and mounting bracket as an assembly.
12. Install the tire and wheel.
13. Remove the safety stands.
14. Lower the vehicle.
15. Adjust parking brake cable.