K 1500 Truck 4WD V8-5.3L VIN T (2000)
Install the rear window reveal molding to the edge of the window.
5. With the aid of an assistant, dry fit the rear window into the opening in order to determine the correct way to position the rear window in the
opening.
6. Use masking tape in order to mark the location of the rear window in the opening.
7. Slit the masking tape at the top edge of the rear window.
8. With the aid of assistant and using suction cups remove the rear window from the opening.
9. Place the rear window inside up on a clean, protected surface.
10. If the original rear window is being reused, remove all but approximately 2 mm (3/64 in) of the existing urethane adhesive from the rear window
surface, using a utility knife or razor blade scraper.
11. Clean around the edge of the inside surface of the rear window with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint
free cloth.
Important: Do not remove all traces of the adhesive. Remove all mounds or loose pieces of urethane adhesive.
12. If the extended method is being used remove all but approximately 2 mm (3/64 in) of the existing bead of adhesive from the pinchweld flange.
13. Shake the pinchweld primer (black #3) for at least one minute.
14. Use a new dauber to apply the primer to the surface of the pinchweld flange.
15. Allow the pinchweld primer to dry for approximately 10 minutes.
16. Use a new dauber to apply the primer to the surface of the pinchweld flange.
17. Shake the pinchweld primer (black #3) for at least one minute.
18. Allow the pinchweld primer to dry for approximately 10 minutes.
Important: Use care when applying the prep (clear #1) on the window. This primer dries almost instantly, but may stain the viewing area
of the window if not applied evenly.
19. Use a new dauber in order to apply glass prep (clear #3) to the area approximately 10 mm to 6 mm (3/8 in to 5/8 in). around the entire perimeter of
the window inner surface.
20. Apply a second coat of the glass prep number (clear #1) to the same area of the glass.
21. Wipe the glass primed area immediately with a clean lint free cloth.
22. Shake the glass primer (black #2) for at least one minute.
23. Use a new dauber in order to apply the glass primer (black #2) to the same areas that glass prep (clear #1) was applied.
