K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
2. Since dust/dirt intrusion has possibly contributed to the seizure of the odometer assembly, the instrument cluster vent holes should be taped over
to prevent further intrusion of contaminants. Using duct tape, cover the holes located on the top, sides and bottom of the cluster. Also, tape over
the rectangular area where the PRNDL indicator assembly is located, trimming away any excess tape as necessary. The PRNDL cable hole can
be taped only if the truck is equipped with a floor mounted shift lever.
3. Install the cluster assembly to the instrument panel using the four screws.
4. If the vehicle has an automatic transmission, install the PRNDL indicator cable.
5.
Reconnect and install the radio and heater control units. Refer to the ACCESSORIES (SEC. 9) and HEATING AND VENTILATION (SEC.
1A) sections of the Service Manual.
6.
Reconnect the battery ground cable.
Service Parts Information
SERVICE PARTS INFORMATION
Part
Quantity
Number
Application
Required
25079944 Odometer with Trip
1
Odometer
25059269
Odometer without Trip
1
Odometer
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty use:
Labor Operation:
N4192
Labor Time:
.7 hr.