K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Fig. 5 Driveshaft retaining ring removal
Fig. 6 Driveshaft & bearing removal
Fig. 7 Thrust plate retaining ring removal
Fig. 8 Thrust plate removal
Prior to disassembly of the pump, remove filler cap and drain fluid. If broken components or foreign materials are found during disassembly, the
hydraulic system should be disassembled, inspected, cleaned and flushed before service is complete.
Refer to Fig. 1, for pump disassembly.
1.
Clean exterior of pump with solvent, then clamp front hub of pump into a soft jaw vise.
2.
Pry tab and slide retaining clip off of pump, Fig. 2.
3.
Remove reservoir, then return tube as follows:
