S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Fig. 11 Oil pump shaft alignment
Fig. 19 Aligning drive & driven rotors
Fig. 20 Oil pump installation
INSTALLATION
1.
Align mark on camshaft with mark on No. 1 rocker arm shaft bracket. Align notch on crankshaft pulley with ``O'' mark on front cover. When these
two sets of marks are properly aligned, No. 4 piston is at top dead center, compression stroke.
2.
Install driven rotor with alignment mark aligned with mark on drive rotor. Fig. 19.
3.
Engage oil pump drive gear with pinion gear on crankshaft so alignment mark on drive gear is turned rearward and approximately 20° from the
crankshaft in a clockwise direction, Fig. 20.
