Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Alignment: Service and Repair
Frame Bracket Knock Out Removal
Frame Bracket Knock Out Removal
Removal Procedure
Important: As originally installed, the upper control arm cannot be adjusted for caster or camber. If the caster and camber is out of specifications, the
caster and camber can be set to the right specifications.
1. Raise the vehicle.
Important: Place safety stands under the lower control arms during the removal and the installation in order to retain the lower control arm position.
2. Remove the tire and the wheel from the vehicle.
3. Remove the upper control arm from the frame bracket.
4. Remove any wax coatings in the knockout area in order to make the stamped outline visible for removing.
5. Use a suitable cutting tool to remove the frame bracket knockout from the frame of the vehicle.
Do not distort the frame bracket when removing the knockout.
6. Repeat the same procedure for the other upper control arm frame bracket knockout.
Installation Procedure
