Savana 2500 V8-6.6L DSL Turbo (2008)
3. Install the caliper bracket mounting bolts (2).
*
Tighten the brake caliper bracket to knuckle bolt to 175 N.m (121 lb ft) for the 15 Series.
*
Tighten the brake caliper bracket to knuckle bolts to 300 N.m (221 lb ft) for 25/35 Series.
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads to the brake caliper bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper. Refer to Front Brake Caliper Replacement (See: Front Brake Caliper Replacement) .
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.