Savana 3/4 Ton Van V6-4.3L VIN X (2003)
6. Refill the fuel tank.
7. Tighten the fuel filler cap.
8. Connect the negative battery cable.
9. Inspect for leaks:
9.1.
Turn ON the ignition for 2 seconds.
9.2.
Turn OFF the ignition for 10 seconds.
9.3.
Turn ON the ignition.
9.4.
Inspect for fuel leaks.
10. Install the engine cover.
Filter to Tank (Rear Tank)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Disconnect the fuel feed pipe the fuel filter.
6. Disconnect the chassis fuel return pipe the rear fuel return pipe.
7. Disconnect the chassis fuel feed and return pipes at the rear fuel feed and return pipes (2).
8. Remove the fuel pipe retaining clips (1).
9. Remove the fuel feed and return pipes.
INSTALLATION PROCEDURE