Savana 3500 V8-4.8L (2009)
completely onto the crankshaft. The second, third, and fourth passes tighten the new bolt to the proper torque.
Note: The balancer should be positioned onto the end of the crankshaft as straight as possible prior to tool installation.
1. Install the crankshaft balancer onto the end of the crankshaft.
2. Use the J 41665 (2, 3) and the J 41478 (1) in order to install the crankshaft balancer.
1. Assemble the J 41478 (1) threaded rod, nut, washer and installer.
Insert the smaller end of the installer into the front of the balancer.
2. Use a wrench and hold the hex end of the threaded rod.
3. Use a second wrench and rotate the installation tool nut clockwise until the balancer is started onto the crankshaft.
4. Remove the tool and reverse the installation tool.
Position the larger end of the installer against the front of the balancer.
5. Use a wrench and hold the hex end of the threaded rod.
6. Use a second wrench and rotate the installation tool nut clockwise until the balancer is installed onto the crankshaft.
7. Remove the balancer installation tool.
