gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Oil Pressure Sender > < Oil Pan Cover Replacement|Page 1940
Page 8
background image

16. Install the transmission cover bolt and tighten to 12 Nm (106 lb in).

17. Raise the front drive axle into position.
18. If equipped with AWD, install the differential carrier upper mounting bolt and nut until snug. Do not tighten at this time.

19. If equipped with AWD, install the differential carrier lower mounting bolt and nut and tighten to 100 Nm (75 lb ft).

20. If equipped with AWD, install the inner axle housing washers and nuts to the bracket and tighten to 100 Nm (75 lb ft).
21. Remove the jack from the front drive axle.
22. Install new engine oil and a new oil filter. Refer to Engine Oil and Oil Filter Replacement   (See: Engine Oil/Service and Repair).

Oil Pressure Sender > < Oil Pan Cover Replacement|Page 1940