Savana 3500 V8-4.8L (2009)
1. Install the suction line into the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the suction line bolt to the compressor and tighten to35 Nm (26 lb ft).
3. Install the rear suction line nut (2) if equipped with rear air and tighten to16 Nm (12 lb ft).
4. Install the suction line nut (1) to the accumulator and tighten to16 Nm (12 lb ft).
5. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (See: Engine, Cooling and Exhaust/Cooling
System/Coolant Reservoir/Service and Repair).
6. Leak test the fittings of the component using the J 39400-A .