Savana 3500 V8-4.8L (2009)
Removal Procedure
Caution: Refer to Power Steering Hose Disconnected Caution (See: Service Precautions).
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
4. Through the wheel well, disconnect the power brake booster outlet hose (1) from the power steering gear (2).
5. Lower the vehicle.
6. Remove the water deflector from the fender.
7. Remove the power brake booster outlet hose (1) from the power brake booster (2).
8. Remove the power brake booster outlet hose from the vehicle.
Installation Procedure
Caution: Refer to Installing Hoses without Twists or Bends Caution (See: Service Precautions/Vehicle Damage Warnings/Installing Hoses
without Twists or Bends Caution).
1. Route the hose in the same position the hose occupied prior to removal.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the power brake booster outlet hose (1) to the power brake booster (2). Hand tighten.
3. Raise the vehicle.
