Savana 3500 V8-4.8L (2009)
Ignition Switch Lock Cylinder: Removal and Replacement
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
2. Remove the ignition switch. Refer to Ignition and Start Switch Replacement (See: Service and Repair).
3. Remove the turn signal cancel cam. Refer to Steering Column Tilt Head Housing Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Tilt Head Housing Replacement).
4. Remove the park lock cable from the lock cylinder housing.
5. Remove 3 TORX(R) screws.
6. Remove the lock cylinder housing from the steering column.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install 3 TORX(R) screws into the lock cylinder housing and tighten to 7 Nm (62 lb in).
2. Install the turn signal cancel cam. Refer to Steering Column Tilt Head Housing Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Tilt Head Housing Replacement).
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch. Refer to Ignition and Start Switch Replacement (See: Service and Repair).
5. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
6. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and setup information.
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure