Savana 3500 V8-6.0L (2007)
Parking Brake Pedal: Service and Repair
Park Brake Pedal Assembly Replacement
Removal Procedure
1. Complete the pedal pin up procedure. Refer to Parking Brake Cable Adjuster Disabling.
2. Remove the release handle.
3. Remove the left side kick panel.
4. Remove the left floor air outlet duct.
5. Remove the pedal retaining nuts.
6. Remove the pedal from the vehicle.
7. Remove the front brake cable from the pedal.
Installation Procedure
1. Connect the front brake cable to the pedal.
2. Install the pedal to the vehicle.
Notice: Refer to Fastener Notice.
3. Install the pedal retaining nuts.
Tighten the pedal retaining nuts to 25 N.m (18 lb ft).
4. Install the left floor air outlet duct.