Suburban 3/4 Ton 4WD V8-305 5.0L (1986)
Service Information - Special Policy
A windshield washer reservoir moisture deflector shield and installation instructions have been sent directly to owners of record. Owners may install the
shield or they may ask a dealer to do the service. Dealer service is to be done at no charge to owners.
If the windshield washer pump on the vehicle fails due to corrosion, install a new pump. This Special Policy will be in effect within a period of five years
from the date the vehicle was originally placed in service. The pump will be replaced at no charge to the owner.
If the owner had previously encountered a failed washer pump due to corrosion, the dealer is to reimburse the vehicle owner with proper documentation;
original paid receipts or invoices verifying expenses incurred for such repairs. The dealer in turn will submit a warranty claim to Chevrolet to pay for the
owner's reimbursement.
This bulletin contains a Special Policy and should be filed in the three-ring binder furnished each dealer by General Motors Corporation in September,
1982.
Service Procedure
Installation of Moisture Deflector Shield
Installation of Moisture Deflector Shield Fig. #1.
1.
Remove cap and retainer from fluid reservoir.
2.
With notch of deflector hole positioned toward rear of vehicle, tuck deflector under the lip of the fender as shown in illustration.
NOTE:
Failure to install deflector as instructed will not provide adequate moisture protection for pump.
3.
Slip hole in deflector over neck of reservoir, then reinstall retainer and cap.
