Yukon XL 2500 2WD V8-8.1L VIN G (2004)
2. Connect the electrical connector to the front seat heater switch assembly.
3. Install the front trim panel.
Heated Seat Switch Replacement - Rear
HEATED SEAT SWITCH REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the center console end panel.
2. Disconnect the electrical connector.
3. Remove the seat heater switch retaining screws.
4. Remove the switch from the vehicle.
INSTALLATION PROCEDURE
1. Install the switch to the console panel.
2. Install the retaining screw.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector.
4. Install the center console end panel.