Accord L4-1955cc 2.0L SOHC 2-bbl (1986)
Ball Joint Remover
7. Disconnect the tie rods form the steering knuckles using the special tool shown.
8. Remove the shift extension from the manual transmission case.
Disconnect the gear shift rod from the transmission case by removing the 8 mm bolt.
9. Remove the center beam bolts and center beam.
1O. Disconnect the exhaust header pipe at the manifold.
Caution: Replace the exhaust gasket and self-locking nuts when you reinstall the pipe.
11. Remove the exhaust header pipe joint nuts.
12. Disconnect the four lines from the control unit.
13. Slide the tie rod all the way to the right side.
14. Remove the steering gear box mounting bolts.
15. Slide the gear box right so that the left tie rod clears the bottom of the rear beam, then remove the gear box.
Installation
1. Reinstall the gear box in the reverse order of removal.
Gear Box Mounts
2. Tighten the gear box mounting bolts.