Accord L4-2.4L (2005)
6. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
1. Start at the bottom edge of the door panel, release the clips that are just above the marks (B) on the edge of the panel with a commercially
available trim pad remover (C).
2. Detach the upper clips.
3. Starting at the rear, pull the door panel upward and over the lock knob (D).
NOTE: The inner handle cable (E) and the courtesy light bulb socket (F) are connected to the door panel. Do not pull the door panel up too
far, or the inner handle cable will be damaged.
7. While holding the door panel (A) away from the door, disconnect the inner handle cable (B) and courtesy light bulb socket (C), and detach the
harness clip (D) from the panel, then remove the panel.
8. If necessary, remove the door glass inner weatherstrip (A) from the door panel (B) by pulling it down.
9. Install the panel in the reverse order of removal, and note these items:
-
Replace any damaged clips.
-
Make sure the connectors are plugged in properly, and the cable and the bulb socket are connected properly.
-
Make sure the window and power door lock operate properly.
-
Driver's: Perform the power window control unit reset procedure.