Accord L4-2.4L (2005)
5. Remove the rear shelf (A).
1. From the trunk compartment, release the hooks (B) from the rear seat-back lock cylinder (C), then remove the lock cylinder trim (D).
2. Lift the rear shelf to detach the clips.
3. Release both rear corner edges (E) of the rear shelf from the rear window opening flange (F), and pull the rear shelf toward the front of the
vehicle.
6. Pull the rear center seat belt (G) out through the slit (H) in the rear shelf.
7. Install the shelf in the reverse order of removal, and note these items:
-
Check the clips for damage or stress-whitening, and replace them with new ones.
-
When installing the rear shelf, slip the rear center seat belt through the slit in the rear shelf.
-
Push the clips and hooks into place securely.
-
Make sure the high mount brake light bulb socket is connected securely.
Special Tools Required
KTC trim tool set SOJATP2014
4-door
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove the C-pillar trim from both sides, without side curtain airbags, with side curtain airbags.