Accord L4-2.4L (2005)
Data Link Connector: Testing and Inspection
DLC Circuit Troubleshooting
NOTE:
-
If the ECM/PCM does not communicate with the HDS, do this troubleshooting procedure.
-
Check that the MIL circuit is normal, then do this troubleshooting.
1. Measure voltage between DLC terminal No.16 and body ground.
Is there battery voltage?
YES - Go to step 2.
NO - Repair open in the wire between DLC terminal No.16 and the No.8 FI ECU (15 A) fuse in the under-hood fuse/relay box.
2. Measure voltage between DLC terminals No.4 and No.16.
Is there battery voltage?
YES - Go to step 3.
NO - Repair open in the wire between DLC terminal No.4 and body ground (G501).
3. Measure voltage between DLC terminals No.5 and No.16.
Is there battery voltage?
YES - Go to step 4.