Accord L4-2.4L (2005)
NO - Repair open in the wire between DLC terminal No. Sand body ground (G503).
4. Turn the ignition switch ON (II).
5. Measure voltage between DLC terminals No.5 and No.7.
Is there 8.5 V or more?
YES - Go to step 11.
NO - Go to step 6.
6. Turn the ignition switch OFF.
7. Jump the SCS line with the HDS.
8. Disconnect ECM/PCM connector E (31P).
9. Check for continuity between DLC terminal No.7 and body ground.
Is there continuity?
YES - Repair short to ground in the wire between DLC terminal No.7 and the ECM/PCM (E23). After repairing the wire, check for a DTC with
the HDS, then go to the indicated DTC's troubleshooting.
NO - Go to step 10.
10. Check for continuity between DLC terminal No.7 and ECM/PCM terminal E23.