Accord L4-2.4L (2005)
Impact Sensor: Service and Repair
Side Impact Sensor
1ST Replacement
Side Impact Sensor (1st) Replacement
NOTE: Review the seat replacement procedure in the Body section before doing repairs or service.
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side airbag 2P connector.
3. Remove the seat assembly.
4. Remove the front door sill trim and the center pillar lower trim panel.
5. Disconnect the floor wire harness 2P connector from the side impact sensor (1st).
6. Remove the Torx bolts (A) using a Torx T30 bit, then remove the side impact sensor (1st) (B).
Installation
1. Install the new side impact sensor (1st) (A) with Torx bolts (B), then connect the floor wire harness 2P connector (C) to the side impact sensor.
2. Reconnect the battery negative cable.
3. Install all removed pants.
4. After installing the side impact sensor (1st), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on
for about 6 seconds and then go off.
2nd Replacement
Side Impact Sensor (2nd) Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side curtain airbag 2P connector.