Accord L4-2.4L (2005)
12. Close the hook portion of the band with commercially available boot band pliers (A), then hook the tabs (B) of the band.
13. Install the boot band on the other end of the boot, and repeat steps 11 through 12.
14. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) on to the boot (B).
NOTE: Pass the end of the new double loop band through the clip (C) twice in the direction of the forward rotation of the driveshaft.
15. Pull up the slack in the band by hand.
16. Mark position (A) on the band 10-14 mm (0.4-0.6 in.) from the clip (B).