Accord L4-2.4L (2005)
17. Thread the free end of the band through the nose section of the commercially available boot band tool (A), and into the slot on the winding
mandrel (B).
18. Using a wrench on the winding mandrel of the boot band tool, tighten the band until the marked spot (C) on the band meets the edge of the clip.
19. Lift up the boot band tool to bend the free edge of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
20. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5-10 mm (0.2-0.4 in.) tail protruding from the clip.