Accord L4-2.4L (2005)
12. If the old quarter glass is to be reinstalled (and either clip is broken off the molding), seal the body holes with pieces of urethane tape (A). Then set
the quarter glass upright in the opening, and make alignment marks (B) across the quarter glass and body with a grease pencil at the three points
shown. Be careful not to touch the quarter glass where adhesive will be applied.
13. Remove the quarter glass.
14. With a sponge, apply a light coat of glass primer along the edge of the front seal (A) and molding (B) as shown, then lightly wipe it off with gauze
or cheesecloth:
-
With the printed dots (C) on the quarter glass (D) as a guide, apply the glass primer to the front portion of the quarter glass.
-
Do not apply body primer to the quarter glass, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from the primed surfaces.