Accord V6-3.0L Hybrid (2005)
-
Spare tire lid
-
Trunk rear trim panel
-
Jack lid
Tie a string to the top end of the rear drain tube (B), then pull back the trunk side trim panel and pull the drain tube down out of the pillar.
6. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
Check the frame seal.
-
Clean the surface of the frame.
-
To install a drain tube, tie the top of the tube to the string that was pulled through when the tube was removed. Use the string to pull the tube
up into the roof.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When installing the rear drain tube at the rear pillar, make sure the cushion on the tube aligns with the hole in the body, and that the alignment
mark on the tube aligns with the upper clip.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
7. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
