Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
1. Measure the clearance between 1st gear and the thrust washer.
-
Standard: 0.06 - 0.23 mm (0.002 - 0.009 inch)
-
Service Limit: 0.23 mm (0.009 inch)
2. If the clearance exceeds the service limit, measure the thicknesses of 1st gear and the thrust washer.
a. 1ST GEAR - Standard: 32.95 - 33.00 mm (1.297 - 1.299 inch)
b. THRUST WASHER - Standard: 1.95 - 1.97 mm (0.077 - 0.078 inch)
NOTE:
-
If the thicknesses of 1st gear and the thrust washer are less than the standard, replace them with new ones.
-
If the thicknesses of 1st gear and the thrust washer are within the standard, replace the 1st/2nd synchro hub with a new one.
3. Measure the clearance between 2nd gear and 3rd gear.
-
Standard: 0.10-0.15 mm (0.004 - 0.006 inch)
-
Service Limit: 0.18 mm (0.007 inch)
4. If the clearance exceeds the service limit, measure the thicknesses of 2nd gear and the spacer.
a. 2ND GEAR - Standard: 28.92 - 28.97 mm (1.139 - 1.141 inch)
b. SPACER - Standard: 29.07 - 29.09 mm (1.1445 - 1.1453 inch)