CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
ASSEMBLE
NOTE:
-
Clean the disassembled parts with solvent, and dry them thoroughly with compressed air. Do not wash the rubber parts with solvent.
-
Thoroughly pack the inboard joint and both joint boots with the joint grease included in the new driveshaft set. Grease quantity: Inboard
Joint/Outboard Joint: 80 - 90 g (2.8 - 3.2 oz).
1. Wrap the splines with vinyl tape to prevent damage to the boots.
2. Install the boots onto the driveshaft, and seat the small end of the boots into the grooves on the driveshaft. If the small ends of the boots are not
seated in the grooves, the boot length adjustment will be incorrect.
3. Remove the vinyl tape from the end of the driveshaft.