Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
Brake Rotor/Disc: Testing and Inspection
Rear
Disc Runout
-
Loosen the rear wheel nuts slightly, then raise the vehicle and support it on safety stands. Remove the rear wheels.
-
Remove the brake pads.
-
Inspect the disc surface for damage and cracks. Clean the disc thoroughly and remove all rust.
-
Use wheel nuts and suitable plain washers to hold the disc securely against the hub, then mount a dial indicator as shown and measure the runout at
10 mm (0.4 in) from the outer edge of the disc. Max. Refinishing Limit: 7.0 mm (0.28 in).
Rear Brake Shoe
-
If the disc is beyond the service limit, replace the brake disc.
NOTE: A new disc should be refinished if its runout is greater than 0.10 mm (0.004 in).
Disc Thickness and Parallelism
-
Loosen the rear wheel nuts slightly, then raise the vehicle and support on safety stands. Remove the rear wheels.
-
Remove the brake pads.