Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
3. Move one end of the spider to cause a trunnion to project through the spider hole beyond the outer machined face of the yoke lug. Place a bearing
over the trunnion diameter and align it to the spider hole. Using an arbor press, hold the trunnion in alignment with the spider hole and place a
solid plug on the upper bearing. Press the bearing into the spider hole enough to install a snap ring.
4. Install a snap ring.
Be sure the snap rings are properly seated in the grooves.
5. Repeat steps 3 and 4 to install the opposite bearing. If the joint is stiff, strike the yoke ears with a soft hammer to seat needle bearings.
6. Align setting marks (1) and join the yokes.
7. Install snap ring.
REASSEMBLY