Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
1. Apply grease evenly to both the female and male splines.
2. Apply a small amount of grease by finger to the outer lips of the boot.
3. Slide the boot onto the yoke shaft being careful not to damage the spline coating or boot.
4. Insert the yoke shaft spline into the sleeve being careful to maintain proper phasing. The spider holes should be in line and as per originally
marked prior to disassembly.
5. Position boot onto sleeve and yoke shaft in final position over boot grooves.
6. Attach boot clamps and secure using pliers.
7. Be sure clamp is properly seated and secure.