Pilot V6-3.5L (2004)
10.
Use a clean shop towel to wipe any dirt from the top edge of the rear window glass and the tailgate. Then use alcohol wipes to clean an area 25
mm above and below the top edge of the glass across its entire width.
11.
Starting 15 mm in from the side edge of the rear window glass, apply foam tape across the width of the glass. Position the tape with the upper 2/3
of the tape above the glass and the lower 1/3 on the glass. Carefully cut the tape 15 mm in from the edge of the glass.
NOTE:
For best results, apply the foam tape in a work area where the ambient temperature is at least 50° F.
12.
Use your hands to press the tape firmly against the glass, then peel off the paper backing.
13.
Reconnect the rear window washer tube.
14.
Reinstall the high mount brake light bulb socket. Reinstall the wire harness, making sure you match the colored tape locations on the harness with
the appropriate spoiler clips.
