Pilot V6-3.5L (2004)
15.
Position the spoiler on the tailgate, then snap it into place.
16.
Open the tailgate.
17.
Reinstall the spoiler mounting nuts. Starting with the middle nut, torque the nuts to 9.8 N.m (7.2 lb-ft). Reinstall the access plug.
18.
Close the tailgate, and measure the height difference between the roof and the front edge of the spoiler. The spoiler must be at least 5 mm lower
than the roof. If the spoiler is too high, remove it, and add a layer of foam tape over the tape under the high mount brake light. Cut the tape the
same length as the high mount brake light indent. Reinstall the spoiler, and remeasure.
19.
Check that the high mount brake light and the rear window washer work properly.
Disclaimer