Pilot 4WD V6-3.5L (2008)
Seat Latch Cable: Service and Repair
Third Row Seat Access Cable
Third Row Seat Access Cable Replacement
NOTE: Take care not to bend the cable.
1. Slide the second row seat forward fully.
2. Remove the pivot bolt cover. Using a T30 TORX bit, remove the pivot bolt from both sides, left second row seat, right second row seat.
3. Remove the second row seat-back cover/pad from the seat-back frame.
4. Left second row seat: Lift the second row seat cushion up, and remove the outer bracket cover and inner bracket cover.
5. Right second row seat: Lift the seat cushion up, and remove the outer bracket cover.
6. Disconnect the third row seat access cable (A) at each end, and remove the screw from behind the left seat-back, then remove the cable(s).
7. Install the third row seat access cable in the reverse order of removal, and make sure the cable is connected securely.