Pilot 4WD V6-3.5L (2008)
14. Pivot the caliper down into position. Install the flange bolt (B), and tighten it to the specified torque while holding the lower caliper pin (C) with a
wrench being careful not to damage the pin boot.
15. Install the brake hose bracket mounting bolt, and tighten it to the specified torque.
16. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheels.
17. Press the brake pedal several times to make sure the brakes work.
NOTE: Engagement may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several applications of the
brake pedal will restore the normal pedal stroke.
18. Add brake fluid as needed.
19. After installation, check for leaks at hose and line joints or connections, and retighten if necessary. Test-drive the vehicle, then check for leaks.
Rear
Rear Brake Pad Inspection and Replacement
CAUTION:
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Inspection
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the rear wheels.
3. Check the thickness (A) of the inner pad (B) and outer pad (C). Do not include the thickness of the backing plate.