Pilot 4WD V6-3.5L (2008)
10. Install the three ignition coils to the front cylinder head.
11. Install the intake manifold.
Rear
1. Check the spark plug seals for damage. If any seal is damaged, replace it.
2. Thoroughly clean the head cover gasket and the groove of the cylinder head cover.
3. Clean the head cover contacting surfaces with a shop towel.
4. Install the head cover gasket (A) in the groove of the cylinder head cover (B). Make sure the head cover gasket is seated securely, then set the
spark plug seals (C) on the spark plug tubes, and install the cylinder head cover.
5. Visually check the spark plug seals for damage.
6. Inspect the cover washers (D). Replace any washer that is damaged or deteriorated.
7. Torque the bolts in three steps. In the final step torque all bolts, in sequence, 12 N-m (1.2 kgf-m, 8.8 lbf-ft).
8. Install the breather hose (A) and harness clamp (B).
9. Torque the two bolts (C) securing the harness holder.
10. Torque the bolt (D) securing the power steering (P/S) hose bracket.
11. Install the three ignition coils to the rear cylinder head.
12. Install the intake manifold.