Pilot 4WD V6-3.5L (2008)
Air Door Actuator / Motor: Service and Repair
Front Air Mix Control Motor Replacement
Front Air Mix Control Motor Replacement
1. Disconnect the 7P connector (A) from the front air mix control motor (B). Remove the rod (C) of the front air mix control motor from the front air
mix control linkage (D). Remove the self-tapping screws and the front air mix control motor from the heater unit.
2. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.