Pilot 4WD V6-3.5L (2008)
4. Jump the SCS line with the HDS.
5. Disconnect PCM connector A (44P).
6. Connect the DLC terminal No. 5 to body ground with a jumper wire.
7. Check for continuity between PCM connector terminal A22 and body ground.
Is there continuity?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes
away with a known-good PCM, replace the original PCM.
NO - Repair open in the wire between the PCM (A22) and DLC terminal No. 5. After repairing the wire, check for Temporary DTCs or DTCs
with the HDS and go to the indicated DTCs troubleshooting.
8. Turn the ignition switch ON (II).
9. Measure voltage between DLC terminals No. 5 and No. 7.
Is there 8.5 V or more?
YES - Go to step 16.
NO - Go to step 10.
10. Turn the ignition switch OFF.
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector A (44P).
13. Check for continuity between DLC terminal No. 7 and body ground.