Pilot 4WD V6-3.5L (2008)
Is there continuity?
YES - Repair short to ground in the wire between DLC terminal No. 7 and the PCM (A43). After repairing the wire, check for a DTC with the
HDS, and go to the indicated DTC's troubleshooting.
NO - Go to step 14.
14. Connect the DLC terminal No. 7 to body ground with a jumper wire.
15. Check for continuity between PCM connector terminal A43 and body ground.
Is there continuity?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes
away with a known-good PCM, replace the original PCM.
NO - Repair open in the wire between DLC terminal No. 7 and the PCM (A43). After repairing the wire, check for a DTC with the HDS, and go to
the DTC troubleshooting.
16. Turn the ignition switch OFF.
17. Jump the SCS line with the HDS.
18. Disconnect PCM connector A (44P).
19. Turn the ignition switch ON (II).
20. Measure voltage between DLC terminals No. 5 and No. 7.