Pilot 4WD V6-3.5L (2008)
Installation
NOTE:
-
If the side airbag lid is secured by tape, remove the tape.
-
Do not open the lid of the side airbag cover.
-
Use new mounting nuts tightened to the specified torque.
-
Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.
-
Be sure to install the harness wires so that they are not pinched or interfering with other parts.
1. Place the new side airbag on the seat-back frame (A). Tighten the side airbag mounting nuts (B).
2. Install the front seat-back cover.
3. Install the front seat assembly, then connect the side airbag harness 2P connector.
4. Reconnect the negative cable to the battery.
5. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with
other parts.
6. After installing the side airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6
seconds and then go off.
Side Curtain Airbag Replacement
Side Curtain Airbag Replacement
Removal
NOTE:
-
Review the interior trim replacement procedure before performing repair or service.
-
Removal of the side curtain airbag must be performed according to the precautions and procedures.
-
The side curtain airbag system consists of the side curtain airbag module, including the roof trim, front grab handle, all grab handle brackets and
shielding protector. When the side curtain airbag has been deployed, these parts should be replaced.
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Remove the headliner.
3. Disconnect the roof wire harness 2P connector (A) from the side curtain airbag.