Pilot 4WD V6-3.5L (2008)
15. Check for continuity between each slip ring and the rotor (B) and the rotor shaft (C).
-
If there is no continuity, replace the rear housing assembly, and go to step 16.
-
If there is continuity, replace the rotor assembly.
Alternator Reassembly
16. If you removed the pulley, put the rotor in the drive end housing, then torque its locknut 110 N.m (11.2 kgf.m, 81.0 lbf.ft).
17. Remove any grease or any oil from the slip rings.
18. Put the rear housing assembly and drive end housing/rotor assembly together, torque the four through bolts.
19. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (0.06 in.) diameter) to hold them there.
20. Install the brush holder, and pull out the pin.
21. Install the end cover.
22. After assembling the alternator, turn the pulley by hand to make sure the rotor turns smoothly and without noise.
23. Install the alternator and drive belt.