Pilot 4WD V6-3.5L (2008)
Shift Cable: Service and Repair
Shift Cable Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS before doing repairs or
service.
1. Remove the steering column covers.
2. Remove the instrument panel.
3. Shift the transmission into the N position.
4. Remove the nut (A) securing the shift cable end, then separate the shift cable (B) from the shift lever.
5. Rotate the socket holder (C) on the shift cable a quarter turn; the tab (D) on the socket holder will be in the opening (E) of the socket holder
bracket (F). Then slide the holder to remove the shift cable from the socket holder bracket. Do not remove the shift cable by pulling the shift cable
guide (G) and damper (H).
6. Make sure you have anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
7. Disconnect the negative cable from the battery, then disconnect the positive cable.
8. Remove the battery hold-down bracket, and remove the battery and battery tray.
9. Remove the intake manifold cover and the intake air duct.
10. Remove the battery base and battery base bracket.
11. Remove the nuts securing the shift cable bracket (A).
12. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
13. Remove the cable clamp (A) from the shift cable bracket (B), and remove the nuts securing the shift cable bracket.