Pilot 4WD V6-3.5L (2008)
14. Remove the shift cable grommet (C), and pull out the shift cable (D).
15. Insert the new shift cable through the grommet hole (E), and install the grommet in its hole. Do not bend the shift cable excessively.
16. Secure the shift cable bracket (A) with the mounting nuts, and install the cable clamp in its bracket.
17. Apply molybdenum grease to the hole in the bushing (B) in the cable end (C). Attach the shift cable end to the control lever (D), then insert the
control pin (E) into the hole in the control lever and through the cable end. Secure the control pin with the spring clip/washer (F).
18. Secure the shift cable bracket with the nuts on the transmission housing.
19. Check that the transmission is in the N position at the control lever on the transmission range switch.
20. Push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not hold the shift cable
guide (B) and damper (C) to adjust the shift position.
21. Place the shift lever in the N position, then insert a 6.0 mm (0.24 in.) pin (A) through the positioning hole (B) on the detent plate, and into the
positioning hole (C) on the control bracket. The shift lever is secured in the N position.