Pilot 4WD V6-3.5L (2008)
22. Align the socket holder (A) on the shift cable (B) with the slot in the socket holder bracket (C), then slide the holder into the bracket. Install the
shift cable end (D) over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Rotate the holder
a quarter turn to secure the shift cable. Do not install the shift cable by twisting the shift cable guide (H) and damper (I).
23. Check that the shift cable end (A) is properly installed on the mounting stud (B).
24. If improperly installed, remove the shift cable from the socket holder bracket, and reinstall the shift cable. Do not install the shift cable end on the
mounting stud while the shift cable is on the socket holder bracket.